Ändra sökning
Länk till posten
Permanent länk

Direktlänk
Lora, Ruben
Publikationer (5 of 5) Visa alla publikationer
Diószegi, A., Lora, R. & Fourlakidis, V. (2014). Dynamic Coarsening of Austenite Dendrite in Lamellar Cast Iron Part 1 – Investigation based on interrupted solidification. Paper presented at 6th International Conference on Solidification and Gravity; Miskolc, Lillafured; Hungary; 2 September 2013 through 5 September 2013. Materials Science Forum, 790-791, 205-210
Öppna denna publikation i ny flik eller fönster >>Dynamic Coarsening of Austenite Dendrite in Lamellar Cast Iron Part 1 – Investigation based on interrupted solidification
2014 (Engelska)Ingår i: Materials Science Forum, ISSN 0255-5476, E-ISSN 1662-9752, Vol. 790-791, s. 205-210Artikel i tidskrift (Refereegranskat) Published
Abstract [en]

Dynamic coarsening of austenite dendrite in lamellar cast iron has been studied for a hypoeutectic alloy. The common morphological parameter to characterize dynamic coarsening, secondary dendrite arm space has been replaced by the Modulus of primary dendrite (MPD) and the Hydraulic diameter of the interdendritic space (DHydIP) to interpret the dynamic coarsening with respect to the local solidification time. The obtained results demonstrate the coarsening process of both the solid and liquid phase. The interdendritic space is increasing as the contact time between the solid and liquid phase increases. The ratio between the DHydIP/MPD is strongly dependent on the precipitated fraction primary austenite indicating clearly the morphology variation during coarsening. The interrupted solidification method demonstrate that the observed coarsening process is not only a combination of the increasing fraction precipitated solid phase and the rearrangement of the solid - liquid interphase curvature but the volume change due to density variation is also contribute to the coarsening process.

Ort, förlag, år, upplaga, sidor
Trans Tech Publications, 2014
Nationell ämneskategori
Metallurgi och metalliska material
Identifikatorer
urn:nbn:se:hj:diva-25446 (URN)10.4028/www.scientific.net/MSF.790-791.205 (DOI)2-s2.0-84901420606 (Scopus ID)
Konferens
6th International Conference on Solidification and Gravity; Miskolc, Lillafured; Hungary; 2 September 2013 through 5 September 2013
Tillgänglig från: 2014-12-30 Skapad: 2014-12-30 Senast uppdaterad: 2025-10-13Bibliografiskt granskad
Fourlakidis, V., Lora, R. & Diószegi, A. (2014). Dynamic Coarsening of Austenite Dendrite in Lamellar Cast Iron Part 2 – The influence of carbon composition. Paper presented at 6th International Conference on Solidification and Gravity; Miskolc, Lillafured; Hungary; 2 September 2013 through 5 September 2013. Materials Science Forum, 790-791, 211-216
Öppna denna publikation i ny flik eller fönster >>Dynamic Coarsening of Austenite Dendrite in Lamellar Cast Iron Part 2 – The influence of carbon composition
2014 (Engelska)Ingår i: Materials Science Forum, ISSN 0255-5476, E-ISSN 1662-9752, Vol. 790-791, s. 211-216Artikel i tidskrift (Refereegranskat) Published
Abstract [en]

Investigation of dynamic coarsening in lamellar cast iron is extended over a wide interval ranging from hypoeutectic to eutectic composition. The dendrite morphology is defined on as-cast samples produced under various cooling rates. The as-cast morphology is considered being close to the one at the end of solidification. The obtained relations describing the coarsening process as a function of local solidification time and fraction austenite are compared to results obtained from interrupted solidification experiments. By using the Modulus of primary dendrite (MPD) and the Hydraulic diameter of the interdendritic space (DHyd IP) become possible to characterize the coarseness of a wide range of lamellar cast irons solidified under various cooling rates. 

Ort, förlag, år, upplaga, sidor
Trans Tech Publications, 2014
Nationell ämneskategori
Metallurgi och metalliska material
Identifikatorer
urn:nbn:se:hj:diva-25447 (URN)10.4028/www.scientific.net/MSF.790-791.211 (DOI)2-s2.0-84901397357 (Scopus ID)
Konferens
6th International Conference on Solidification and Gravity; Miskolc, Lillafured; Hungary; 2 September 2013 through 5 September 2013
Tillgänglig från: 2014-12-30 Skapad: 2014-12-30 Senast uppdaterad: 2025-10-13Bibliografiskt granskad
Lora, R., Fourlakidis, V., Díaz de Aguilar, A. & Diószegi, A. (2011). Characterization of the Primary Austenite Dendrite and Interdendritic Space in Lamellar Cast Iron.
Öppna denna publikation i ny flik eller fönster >>Characterization of the Primary Austenite Dendrite and Interdendritic Space in Lamellar Cast Iron
2011 (Engelska)Rapport (Övrigt vetenskapligt)
Förlag
s. 14
Serie
JTH Research Reports, ISSN 1404-0018 ; 2011:01
Nationell ämneskategori
Materialteknik
Identifikatorer
urn:nbn:se:hj:diva-17609 (URN)
Tillgänglig från: 2012-02-07 Skapad: 2012-02-07 Senast uppdaterad: 2025-10-13Bibliografiskt granskad
Lora, R. & Diószegi, A. (2011). Dynamic Coarsening of 3.31C-1.89Si Grey Cast Iron.
Öppna denna publikation i ny flik eller fönster >>Dynamic Coarsening of 3.31C-1.89Si Grey Cast Iron
2011 (Engelska)Rapport (Övrigt vetenskapligt)
Förlag
s. 9
Serie
JTH research report, ISSN 1404-0018
Nationell ämneskategori
Materialteknik
Identifikatorer
urn:nbn:se:hj:diva-17610 (URN)
Tillgänglig från: 2012-02-07 Skapad: 2012-02-07 Senast uppdaterad: 2025-10-13Bibliografiskt granskad
Lora, R., Dioszegi, A. & Elmquist, L. (2010). Solidification Study of Gray Cast Iron in a Resistance Furnace. In: Adel Nofal and Mohamed Waly (Ed.), Science and Processing of Cast Iron IX. Paper presented at Ninth International Symposium of Science and Processing of Cast Iron (SPCI-9) (pp. 108-113). Switzerland: Trans Tech Publications Ltd.
Öppna denna publikation i ny flik eller fönster >>Solidification Study of Gray Cast Iron in a Resistance Furnace
2010 (Engelska)Ingår i: Science and Processing of Cast Iron IX / [ed] Adel Nofal and Mohamed Waly, Switzerland: Trans Tech Publications Ltd. , 2010, s. 108-113Konferensbidrag, Publicerat paper (Refereegranskat)
Abstract [en]

Solidification of hypoeutectic gray cast iron has been investigated in a resistance furnace. A cylindrical shaped sample with three thermocouples, two inside and one in the surrounding, was solidified and compared to samples quenched at different stages during the solidification interval. An additional sample in the series has been produced to reveal the primary grain structure using Direct Austempering After Solidification (DAAS) treatment. The present paper collect for the first time under the same experimental procedure the solidification of a hypoeutectic gray cast iron where both the growth of the primary and eutectic phase are observed. An increase of the secondary dendrite arm spacing (SDAS) was observed until the end of the solidification interval. A comparison of the measured solidified fractions of the phases with those predicted using Fourier Thermal Analyses evidenced the quenching effectiveness. The eutectic cell size is in agreement with the literature. The method presents good consistency.

Ort, förlag, år, upplaga, sidor
Switzerland: Trans Tech Publications Ltd., 2010
Serie
Key Engineering Materials, ISSN 1013-9826 ; 457
Nyckelord
Gray cast iron, interrupted solidification, primary grains, thermal analysis, DAAS.
Identifikatorer
urn:nbn:se:hj:diva-14227 (URN)13 978-0-87849-227-5 (ISBN)
Konferens
Ninth International Symposium of Science and Processing of Cast Iron (SPCI-9)
Tillgänglig från: 2011-01-08 Skapad: 2011-01-07 Senast uppdaterad: 2025-10-13Bibliografiskt granskad
Organisationer

Sök vidare i DiVA

Visa alla publikationer