Feasibility study on the Laser Aided Additive Manufacturing of die inserts for liquid forging
2010 (Engelska)Ingår i: Materials & Design, ISSN 0261-3069, Vol. 31, nr SUPPL. 1, s. S112-S116Artikel i tidskrift (Refereegranskat) Published
Abstract [en]
This paper reports the Laser Aided Additive Manufacturing of nickel-base alloy Nimonic 80A for the purpose of direct building of die inserts for liquid forging. Low porosity level of 0.01-0.04% with reasonable deposition rate was achieved. The micro-hardness showed very good homogeneity. Directionally solidified cellular micro-structure with an average size of 5Όm was observed. Very fine MC-type carbides were detected at the grain boundaries, which function as the strengthening phase of the alloy. © 2009 Elsevier Ltd.
Ort, förlag, år, upplaga, sidor
2010. Vol. 31, nr SUPPL. 1, s. S112-S116
Nyckelord [en]
Laser Aided Additive Manufacturing, Liquid forging, Nickel-base alloy, Additive Manufacturing, Average size, Die insert, Directionally solidified, Feasibility studies, Low porosity, Nickel base alloys, Nimonic 80A, Strengthening phase, Alloys, Carbides, Dies, Forging machines, Forgings, Grain boundaries, Liquids, Manufacture, Nickel, Nickel alloys, Cerium alloys
Nationell ämneskategori
Materialteknik
Identifikatorer
URN: urn:nbn:se:hj:diva-16636DOI: 10.1016/j.matdes.2009.10.039OAI: oai:DiVA.org:hj-16636DiVA, id: diva2:454428
2011-11-072011-11-072015-06-01Bibliografiskt granskad